How To: Customize the Default Image in the Link to Accept (L2A) Email

Version Affected: All

 

Overview

This article explains how to replace the default image used in Link to Accept (L2A) emails. The image is controlled from the SecureAuth0 realm and applies to every realm on the appliance. By default, the image is the SecureAuth logo banner shown below.

Replace the Default Image

1. Open D:\SecureAuth\SecureAuth0\customEmail\ready\0000000000000000.
2. Back up the existing preview.png file.
3. Copy your replacement image, also named preview.png, into that folder.

Special Considerations

The same folder also contains a meta.csv file, which can be used for further customization of the email.


 

SecureAuth Knowledge Base Articles provide information based on specific use cases and may not apply to all appliances or configurations. Be advised that these instructions could cause harm to the environment if not followed correctly or if they do not apply to the current use case.

Customers are responsible for their own due diligence prior to utilizing this information and agree that SecureAuth is not liable for any issues caused by misconfiguration directly or indirectly related to SecureAuth products.